Abstract
Alumina‐glass composites were prepared by a melt‐infiltration process that is similar to a fabrication method for dental crowns and bridges. Cylindrical alumina samples with green densities ranging from 62% to 72% of theoretical were formed by slip casting followed by sintering at 1100°C for 2 h. A borosilicate glass was infiltrated at 1200°C, resulting in a composite microstructure consisting of fused alumina particles and glass‐filled pores. Fracture toughness of the composites, measured by a chevron‐notch method with a short rod sample, was ∼3.8 MPa·m1/2 and was relatively insensitive to the volume fraction of alumina in the range of 0.62 to 0.72.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.