Medium-Term Outcomes of a Forward-Striking Technique to Reduce Fracture Gaps during Long Cephalomedullary Nailing in Subtrochanteric Femoral Fractures

Abstract

IntroductionA residual fracture gap after intramedullary nailing is a known risk factor for delayed union and non-union. This study aimed to report the outcomes of a forward-striking technique to reduce fracture gaps during long cephalomedullary nailing in subtrochanteric femoral fractures (SFFs). MethodsA retrospective cohort study was conducted on patients with SFFs treated in a single institution between February 2013 and October 2018. A total of 58 patients treated via long cephalomedullary nailing with a forward-striking technique were included. The width of the fracture gap, location of the cephalic screw, tip-apex distance (TAD), and time to bone union were evaluated using intraoperative and postoperative radiographs. Complication rates, including fixation failure, non-union, implant breakage, and infection, were assessed. The mean follow-up duration was 4 (range, 2‒8) years. ResultsOf the 58 patients (mean age, 67.9 years), 38 (65.5%) were female. Thirty-two cases (55.2%) were classified as atypical femoral fractures. The mean fracture gap reduced from 5.1 mm to 1.6 mm by forward striking (P<0.001). The reduced fracture gap was significantly greater in atypical SFFs (mean, 4.9 mm vs. 1.7 mm; P<0.001). The lag screw was located in the center-center or center-inferior zones of the femoral head in 54 patients (93.1%). The mean TAD was 14.2 mm and was under 25 mm in 55 patients (94.8%). Bone union was achieved in all cases without reoperation at a mean of 5.4 months. One incident of lag screw breakage was noted at 5 months, but bone union was achieved at 7 months. ConclusionsThe forward-striking technique with a long cephalomedullary nail demonstrated a 100% bone union rate in a consecutive series of 58 SFFs. This technique is effective in reducing the fracture gap as well as placing the cephalic screw into the optimal position. The forward-striking technique was particularly effective in reducing atypical SFFs with a transverse or short oblique configuration.