Abstract

Conventional medium access control protocols are designed to avoid simultaneous transmissions, based on a simple collision model in the underlying physical layer. Recently, strong physical layer capabilities, enabled by multiuser detection techniques, have been studied in connection with simple medium access control protocols, for example, slotted ALOHA. We think that neither of these extreme approaches is optimum, particularly in general scenarios where network nodes with different signal processing capabilities coexist. Instead of dealing with interferences in either of the two layers alone, both medium access control and physical layer functionalities should be designed to cooperate and complement each other. We discuss several key aspects for designing such a protocol, especially with an emphasis on iterative multiuser detection, which can provide a good tradeoff between performance and complexity. We propose a new protocol called MUD-MAC which satisfies these key aspects. We analyze its throughput bound and also perform numerical simulations. The simulation results show excellent throughput improvements. It is also demonstrated that the MUD-MAC protocol provides certain fairness among network nodes with different signal processing capabilities.

Highlights

  • It is demonstrated that the multiuser detection (MUD)-medium access control (MAC) protocol provides certain fairness among network nodes with different signal processing capabilities

  • Medium access control (MAC) protocols in ad hoc networks are designed to avoid simultaneous transmissions based on a simple collision model in the physical (PHY) layer

  • We addressed key requirements and crosslayer aspects for the design of a MAC protocol which copes with interference by tightly cooperating with the PHY layer, with an emphasis on iterative multiuser detection as a flexible means for interference cancellation

Read more

Summary

Introduction

Medium access control (MAC) protocols in ad hoc networks are designed to avoid simultaneous transmissions based on a simple collision model in the physical (PHY) layer. In contrast to the uplink of cellular networks, power control in ad hoc networks may be impractical because the required power level can be completely different at different receiver locations To clarify this argument, let us consider the scenario illustrated on the EURASIP Journal on Advances in Signal Processing left-hand side of Figure 1, where the two transmitters T1 and T2 have data to send to the receivers R1 and R2 using the signatures S1 and S2, respectively. Both MAC and PHY layer functionalities should be designed so as to cooperate and complement each other This is important in general scenarios where network nodes with different signal processing capabilities coexist. Such an integrated design of MAC and PHY functionalities is the main goal of this article.

Iterative Multiuser Detection
Medium Access Control Protocol Design
A new medium access control protocol
CrossLayer Aspects
Numerical Results d 75 m
Confidence level
Conclusions
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.