Mechanosynthesis of metastable cubic δ-Ta1−xN

Abstract

The formation of the cubic δ-Ta1−xN phase by high-energy ball-milling from tantalum and boron nitride (h-BN) is explored. Two different molar ratios Ta:BN, 1:1 and 2:1, were used. X-ray diffraction, scanning electron microscopy, surface area analysis by the Brunauer-Emmett-Teller method, and thermogravimetric analysis were used to characterize the products obtained. In both molar ratios and after a few minutes of milling, the mechanosynthesis of δ-Ta1−xN was observed. Increasing the entropy of the system by introducing vacancies and point defects by the high-energy ball-milling process seems to stabilize the cubic δ-Ta1−xN phase, as previous theoretical studies had reported. The phase obtained depends on the molar ratio used: in the molar ratio 1:1 a non-stoichiometric δ-Ta1−xN phase is obtained, while in the molar ratio 2:1 a stoichiometric δ-TaN phase and secondary phases are obtained. The amorphous boron remains dispersed in the material until the mechanical energy is high enough to trigger the formation of tantalum borides.