Abstract
Automobiles are equipped with EGR (Exhaust Gas Recirculation) coolers to improve fuel economy and exhaust gas suppression performance. Inside the EGR cooler, the moisture in the gas is condensed by cooling the hot exhaust gas. This condensed water is highly corrosive because sulfur oxides dissolve. Therefore, stainless steel and Ni-based brazing metal having excellent corrosion resistance are used for the EGR cooler.Until now, stainless steel has been brazed under a vacuum atmosphere. However, there are increasing opportunities to braze stainless steel in an inert atmosphere gas at atmosphere for cost reduction and mass production. In this case, a paste-type brazing filler metal consisted of a powder brazing filler metal and a binder is used. As is well known, a debinding process that volatilizes the binder is needed. From previous research in this laboratory, it is clarified that the binder causes voids. In addition, it is said that the size and location of voids generated at the brazed joint affect the product performance. On the other hand, the detailed investigation about the influence which the installation position of a paste type brazing filler metal on the void formation process has not yet been made. Therefore, in this study, the arrangement method and influence on heating rate and debinder temperature on void formation were investigated by X-ray CT.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
