Mechanism of high dielectric performance of polymer composites induced by BaTiO3-supporting Ag hybrid fillers

Abstract

BaTiO3-supporting Ag hybrid particles (BT-Ag) with varied fraction of Ag were synthesized by reducing silver nitrate in the glycol solution containing BaTiO3 (BT) suspensions. The Ag nano particles with a size of about 20 nm were discretely grown on the surface of the BT. The dielectric performance of the composites containing the BT-Ag as fillers in the matrix of polyvinylidene fluoride (PVDF) was investigated. The relative permittivity (εr) of the BT-Ag/PVDF composites increased prominently with the increase of BT-Ag loading amount, and the typical conductive path of the conductor/polymer system was not observed even with a high loading of BT-Ag. The εr at 100 Hz for the three BT-(0.31, 0.49, 0.61)Ag/PVDF composites at room temperature were 283, 350, and 783, respectively. The εr of the composites was enhanced by more than 3 times compared with that of the composite containing untreated BT nanoparticles at frequencies over 1 kHz and the loss tangent (tan δ) was less than 0.1 which should be attributed to the low conductivity of the composites. Theoretical calculations based on the effective medium percolation theory model and series-parallel model suggested that the enhanced permittivity of BT-Ag/PVDF composites should arise from the ultrahigh permittivity of BT-Ag fillers, which was over 104 and associated with the content of Ag deposited on the surface of BT.