Mechanism and Influence Factors of Abrasion Resistance of High-Flow Grade SEBS/PP Blended Thermoplastic Elastomer.

Abstract

Hydrogenated styrene-butadiene-styrene block copolymer (SEBS)/polypropylene (PP) blended thermoplastic elastomer (TPE) is suitable for preparing the automotive interiors because of its excellent elasticity, softness, weather resistance, low odor, low VOC and other environmental-friendly properties. The skin of the automobile instrument panel is an appearance part, which requires excellent friction loss resistance of surface. In this paper, the high-flow SEBS/PP blended thermoplastic elastomer (TPE) suitable for the preparation of injection molding skins for automobile instrument panel was studied. By comparing the Taber abrasion and cross-scratch properties, the effects of SEBS’s molecular weight, styrene content in the molecule, molecular structure and types of lubricating agents on the friction loss properties of the material were investigated. The results show that under the same SEBS molecular structure, the higher the molecular weight within a certain range, the better the wear resistance of high-flow SEBS/PP type TPE, but the ultra-high molecular weight exhibits lower wear resistance than high molecular weight; The high-flow SEBS/PP blended TPE prepared by medium styrene content SEBS has better abrasion resistance; TPE prepared by star SEBS is better than linear SEBS; Adding silane-based lubricating agents is beneficial to improve the friction loss resistance of the material, especially combined use of high and low molecular weight silicone.