Abstract

Due to the introduction of silicon carbide reinforcement, the physical and cutting properties of SiCp/Mg composites are very different from those of metal composites. Nanosecond pulse laser processing is more efficient than traditional processing for SiCp/Mg composites. A low-power pulsed fiber laser was used to etch 3.0 mm thick SiCp/Mg composites. The effect of low laser power (0~50 W) on the morphology and heat-affected zone of the SiCp/Mg composite after etching was studied. The results show that when the laser power increases, the material accumulation at the ablation end of the machining surface becomes more and more serious. With the increase in power, the differences in ablation width and ablation depth on the surface of composite materials do not increase proportionally. When the laser power increases gradually, the width of the heat-affected zone increases in the direction of the perpendicular laser beam and reaches the maximum value at the etched end.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.