Mechanical vascular division in lung resection

Abstract

There is little information available regarding the relative advantage of stapling over ligation for major pulmonary vessels in lung resection. The thin and fragile structure of pulmonary vascular walls for their large luminal size might have made surgeons reluctant to use staplers. This study was intended to demonstrate the feasibility of pulmonary vascular division by staplers. A total of 842 mechanical vascular divisions were performed for pulmonary artery (PA, n=376), pulmonary vein (PV, n=462), and azygos vein (AV, n=4) in 603 consecutive pulmonary resections from 1997 to 1999 at the National Cancer Center Hospital, Tokyo. In this series, 99.8% of mechanical vascular divisions were performed with endostaplers (840 vessels), and only 0.2% was performed with conventional TA-type staplers (two vessels). The prevalence of problems related to mechanical stapling (stapling failure) and postoperative bleeding was studied retrospectively. There was only one incidence of stapling failure, in which the superior pulmonary vein was divided without the formation of staples (overall stapling failure rate, 0.1%). The bleeding was controlled by ligation of each divided stump during thoracotomy. There was no stapling failure for PAs or AVs. In no case did postoperative bleeding require rethoracotomy at the stapled line of the vessels. Although temporary oozing was sometimes seen along the staple line, vascular division with endostaplers was highly reliable with only a 0.1% incidence of stapling failure for all kinds of vascular structures in the thorax.