Mechanical, thermal, and microstructure analysis of 3D printed polyolefin elastomer-acrylonitrile butadiene styrene blends for tunable mechanical properties

Abstract

Listen

Translate article

Fused Deposition Modeling (FDM) has emerged as a cost-effective and user-friendly technique that has garnered significant attention in recent years. However, challenges persist when printing soft materials using FDM technology. This study proposes a solution by blending a soft polyolefin elastomer (POE) with a stiffer material, acrylonitrile butadiene styrene (ABS). A comprehensive experimental investigation utilizing a direct pellet printing method was conducted to 3D print POE-ABS blends in various ratios (10%, 30%, and 50% ABS content). The study encompassed material preparation, 3D printing, SEM (Scanning Electron Microscopy) analysis, Dynamic Mechanical Thermal Analysis (DMTA), uniaxial tensile testing, and compression testing to assess the mechanical properties and energy absorption capabilities of the 3D printed blends. The results of the DMTA showed that the blends with a higher amount of ABS have a larger area under the Tan δ curve, indicating their ability to absorb more energy. The SEM images revealed that as the proportion of ABS increases, the gaps between layers and beads become smaller. The mechanical properties of the pure printed POE, such as its elongation at break and tensile strength, were 2138% and 2.83 MPa, respectively. However, as the ABS content increased, the samples exhibited more rigid behavior, with a final transition to 50/50 ratio resulting in 9.4 MPa tensile strength and 160% elongation at break. The energy absorption test demonstrated that the sample with 30% ABS content has the highest energy absorption capability among all the tested samples. This research underscores the potential of blending soft and stiff materials to tailor properties for additive manufacturing applications, emphasizing the significance of material composition in achieving desired mechanical performance, printability, and functionality in printed objects.