Mechanical, thermal, and micro‐ and nanostructural properties of polyvinyl chloride/graphene nanoplatelets nanocomposites

Abstract

AbstractThis article describes micro‐ and nanostructural, mechanical, and thermal properties of nanocomposites based on polyvinyl chloride (PVC) and graphene nanoplatelets (GNP). The primary objective of this study was to extend restricted application area of PVC due to its low thermal stability and limited mechanical properties. GNP‐filled PVC nanocomposites were prepared (0, 0.1, 0.3, 0.5, and 1.0 wt%) by colloidal blending method and characterized in detail. The highest value of the tensile strength 13.73 MPa (an increase of 58%) and the highest value of microhardness 83.42 MPa (an increase of 82%) were obtained with GNP loading content of 0.5 wt% compared neat PVC. The mechanical properties started to decrease at loading higher than 0.5 wt%; however, the thermal properties continued to increase. The differential scanning calorimetry and Fourier transform infrared analysis results of this nanocomposite confirmed that the increase in glass transition temperature from 34.99°C to 44.36°C and the decrease in the height of functional groups peaks proved to prevented segmental relaxation and intermolecular vibrations of PVC, respectively. Thermogravimetric analysis results were showed that the percentage of carbonaceous residue increased to 15.77% by increasing the GNP content from 0.1 to 0.5 wt%. As a result, the best GNP loading was at 0.5 wt% for PVC/GNP nanocomposites where mechanical and thermal properties of PVC/GNP were both enhanced.