Year-end Sale % OFF 
Abstract
Diagnostic pressure gauges (DPGs) shall provide measurements of the neutral gas pressure in various locations of the International Thermonuclear Experimental Reactor (ITER) vacuum vessel. This parameter is essential for the basic control of ITER operation as well as for input to physics models of the plasma boundary. The hot cathode (filament) is the component of the DPG sensor that is exposed to most demanding loads. In order to reach the required electron emission from the filament, it has to be heated to high temperatures by a direct current. As a result, thermal stresses appear, and in the presence of a magnetic field, additional mechanical stresses caused by Lorentz forces arises. On the one hand, due to a large number of pulses foreseen in ITER, this load will be cyclic, which may result in filament failure caused by fatigue. On the other hand, the longest pulses in ITER are expected to be in the order of 30 min, and thus, filaments could fail due to creep. In order to verify that the filament of the DPG sensor can withstand fatigue and creep dedicated experiments have been conducted. Results of these tests are discussed in this article.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
