Mechanical Properties of Thermoplastic and Thermoset Composites Reinforced with 3D Biaxial Warp-knitted Fabrics

Abstract

In this study, two types of thermoplastic matrices (low melting point polyethylene terephthalate (LPET) fiber and polypropylene (PP) fiber) and glass fiber/epoxy resin/multi-walled carbon nanotubes (MWCNTs) were used to fabricate the thermoplastic and thermoset composite materials with 3D biaxial warp-knitted fabrics. Thermoplastic and thermoset composites were fabricated using hot-press and resin transfer molding (RTM) methods. The fabricated samples were tested with tensile and three-point flexural tests. In thermoplastic composites, samples in the 90° direction and LPET matrix showed the best tensile and flexural properties with an improvement of 39 and 21% tensile modulus and strength, 16 and 8% flexural modulus and strength compared to the PP samples in the same direction. In thermoset composites, samples in the 90° direction and MWCNTs showed the best improvement of the flexural modulus and strength with 97 and 58% compared to the samples without MWCNTs. This improvement can most likely be attributed to an increase in interfacial adhesion due to the presence of the carbon nanotubes.