Abstract
The manuscript presents the results of butt joining of 3-millimeter-thick AlCu4Mg1 alloy sheets using the FSW (friction stir welding) and UWFSW (underwater friction stir welding) methods. The aim of the research is to verify the influence of the water environment on the FSW friction welding process. The article checked three sets of joint parameters. The parameters differed in tool rotation speed and feed rate. The same sets of parameters were used for the FSW and UWFSW fusion techniques. With the supplied devices, metallographic sections are cross-sectioned, and the power supplies are subjected to a light microscope. Microhardness tests and the influence of the heat-affected zone were carried out. A monotonic test was performed. A monotonic test is available, extended with a visual correlation test. The obtained cracked fracture surfaces were examined using a scanning microscope. An analysis of the microfractographic cracking process was carried out. The obtained results did not show any improvement in the strength properties of the obtained joints made using the UWFSW technique when using a scanning microscope.
Sign-in/Register to access full text options 
Free) 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
