Mechanical Properties of Slag-Based Geopolymer Grouting Material for Homogenized Micro-Crack Crushing Technology

Abstract

Homogenized micro-crack crushing can fully retain the bearing capacity of concrete pavement, but local weak road base needs to be reinforced before being directly overlaid with hot-mixed asphalt. Therefore, indoor tests were conducted to study the mechanical properties of slag-based geopolymer as a grouting material for weak road base, and the morphology and influence of polymerization reactants were observed. Concurrently, on-site grouting tests were conducted to study the grouting effect. The results show that the compressive strength, flexural strength and bonding strength of slag-based geopolymer all increase with age. The maximum compressive strength and flexural strength of the geopolymer at 28 d were 18.88 MPa and 6.50 MPa, respectively. The maximum flexural bonding strength at 14 d was 4.58 MPa. As the ratio between water and slag powder increased, the compressive strength and flexural strength gradually decreased, while the bonding strength first increased and then decreased. In the range of ratios of water to slag powder from 0.26 to 0.28, the above three strengths were relatively high, and the compressive shear bonding strength was the highest when the ratio of water to slag powder was 0.28. The shrinkage of the slag-based geopolymer increases with the increase in ratio of water to slag powder, and the porosity also increases, resulting in a decrease in compactness after consolidation. When the ratio of water to slag powder was 0.28, the reactant was mainly a gel-phase material, and the shrinkage crack of the consolidated geopolymer was relatively small. After grouting the weak road base of the concrete pavement, the voids at the bottom of the concrete pavement slab were effectively filled, and the deflection of the pavement slab was significantly reduced. The average deflections of monitoring line I, monitoring line II and monitoring line III decreased by 49%, 41% and 54%, respectively, after grouting. After solidification, the slag-based geopolymer was distributed in layers, which further compacted the road structure layer and improved the bearing capacity.