Abstract
Ni – Si alloys are used in the manufacture of heat-resistant coatings. However, due to the fact that the production of compact specimens presents considerable difficulties are insufficient data in the literature on their mechanical properties. In this work, the manufacturing techniques Ni – Si alloys for mechanical testing, which consists in melting the alloy under pressure, cooling the alloy under pressure and pressure drop. Polished sample was made of samples with different chemical composition, their structure and microhardness were studied. As a result, the study found that by increasing silicon content up to 30 – 40 % microhardness Ni – Si alloys decreases to 5.5 – 6.0 GPa, with a further increase in the silicon content microhardness increases signifi cantly, due to the presence of the phase structure NiSi2 and Si, that have high microhardness values.
Highlights
Ni – Si alloys are used in the manufacture of heat-resistant coatings
The manufacturing techniques Ni – Si alloys for mechanical testing, which consists in melting the alloy under pressure, cooling the alloy under pressure and pressure drop
Polished sample was made of samples with different chemical composition, their structure and microhardness were studied
Summary
Никелькремниевые сплавы находят применение при изготовлении жаростойких покрытий. В представленной работе разработана технология изготовления никелькремниевых сплавов для проведения механических испытаний, заключающаяся в плавлении сплава под давлением, охлаждении сплава под давлением и снижении давления. Сплавы никеля с кремнием широко распространены в промышленности в качестве жаростойких покрытий [1], связок алмазных композиционных материалов [2]. Что сплавы с большим содержанием кремния обладают повышенной хрупкостью, имеют большое количество трещин и представляют значительные трудности при изготовлении стандартных образцов для механических испытаний. Проведенное в работе [4], свидетельствует о сильном химическом взаимодействии в расплаве никель – кремний. Целью настоящей работы являлось изучение механических свойств сплавов системы никель – кремний. При изготовлении сплавов было отмечено, что сплавы, содержащие 60, 70 и 100 % Si имели «отрицательную» усадочную раковину. Составы изготовленных сплавов и результаты их рентгенофазового анализа представлены в табл
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Izvestiya Visshikh Uchebnykh Zavedenii. Chernaya Metallurgiya = Izvestiya. Ferrous Metallurgy
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.