Mechanical properties of injection molded long fiber polypropylene composites, Part 2: Impact and fracture toughness

Abstract

AbstractThis study describes the effect of fiber length and compatibilizer content on notched izod impact and fracture toughness properties. Long fiber polypropylene (LFPP) pellets of different sizes were prepared by extrusion process using a new radial impregnation die, and subsequently, pellets were injection molded as described in previous publication 1. The content of glass fiber reinforcement was maintained same for all compositions. Maleic‐anhydride grafted polypropylene (MA‐g‐PP) was chosen as a compatibilizer to increase the adhesion between glass fiber and PP matrix and its content was maintained at 2 wt%. Notched izod impact property was studied for LFPP composites prepared with and without compatibilizer for different pellet sizes. Failure mechanism due to sudden impact was analyzed with scanning electron micrographs and was correlated with impact property of LFPP composites. Fracture and failure behavior of injection molded LFPP composite were studied and relationship between fracture toughness and microstructure of LFPP composite was analyzed. The microstructure of the composites was characterized by the dimensionless reinforcing effectiveness parameter, which accounts for the influence of fiber layer structure, fiber alignment, fiber volume fraction, fiber length distribution, and aspect ratio. Matrix stress condition factor and energy absorption ratio were determined for LFPP composites prepared with and without compatibilizer. Failure mechanism of both the matrix and fiber, revealed with SEM images, were discussed. POLYM. COMPOS., 2008. © 2008 Society of Plastics Engineers