Abstract
The use of mengkuang fiber (MK) as a filler in NR/HDPE/MK bio-composite was investigated. The suitability of MK as reinforcing filler was studied in terms of the mechanical properties and phase morphology formed. Melt-blending was performed using an internal mixer (Haake Rheomix 600). The processing parameters identified were 135 °C temperature, 45 rpm rotor speed and 12 min processing time. The optimum MK loading in 40/60 of NR/HDPE blend was obtained at 20 wt.% with the tensile strength, tensile modulus, and impact strength of 12.4 MPa, 377 MPa and 17.2 kJ/m2, respectively. These results showed an enhancement in tensile strength of 10.7% compared to the unfilled NR/HDPE blend. The maximum impact strength obtained at 5% fiber loading was 23.5 kJ/m2, which was 7.8% higher compared to unfilled NR/HDPE blend. The FESEM micrographs showed good adhesion between MK fiber and matrix. These mechanical properties enhancements proved the suitability of mengkuang fiber as potential reinforcing filler in NR/HDPE blend.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.