Abstract
Increase of quality and productivity in the same time are the most important in automotive industry. Use of high-strength steel 22MnB5 allows decrease of sheet metal thickness compared to standard steel. Commonly the steel 22MnB5 is welded with laser [1]. Use of this steel for spot resistance welding is not yet fully described. Steel 22MnB5 is coated with Al-Si galvanic coating for increasing high temperature oxidation resistance [2]. During hot stamping and subsequent heat treatment diffusion layer is created between coating and steel. The thickness of this layer is strongly dependent on temperature and time of heat process [3]. The paper deals with mechanical properties (chemical composition, indentation hardness) of this diffusion layer and Al-Si coating. Different thicknesses of diffusion layers were compared and its influence on weldability was described. Thin thicknesses have negligible effect on weldability, yet large thicknesses very negatively influence the weldability.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
