Abstract
Mechanical properties of Al-12Zn-2.4Mg-1.2Cu alloy extruded sheet were investigated by tensile tests. Microstructures were investigated by optical microscopy (OM) and scanning electron microscope (SEM). The result shows that no matter in the L direction or in the T direction, the tensile strength and yield strength decrease with the increasing of the extrusion temperature in different states. The tensile strength and yield strength in the L direction are higher than in the T direction at different extrusion temperatures and different treatment states. When temperature is 340°C, the highest tensile strength is 780 MPa and the highest yield strength is 753 MPa in the two-stage solution and two-stage aging state. The reason for the higher mechanical properties are in the L direction in different states is mainly depend on the distribution direction of the grains.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
