Mechanical properties and frictional behavior of SiCp/Al-Si-Cu-Ni-Mg hybrid composites at an elevated temperature

Abstract

PurposeThis paper aims to investigate the effect of Cu content and T6 heat treatment on the mechanical properties and the tribological performance of SiCp/Al-Si-Cu-Ni-Mg hybrid composites at an elevated temperature.Design/methodology/approachThe stir casting method was used to synthesize SiCp/Al-12Si-xCu-1Ni-1Mg (x = 2, 3, 3.5, 4, 4.5, 5 Wt.%) composites containing 20 vol% SiC. The hardness and tensile strength of the aluminum matrix composites (AMCs) at room temperature and elevated temperature were studied, and the wear mechanism was investigated using scanning electron microscopic and energy dispersive spectroscopy.FindingsResults indicate that the hardness and tensile strength of the AMCs are affected significantly by T6 heat treatment and Cu content. The high-temperature friction and wear mechanism of AMCs is the composite wear mechanism of oxidation wear, adhesion wear, abrasive wear, peeling wear, high-temperature softening and partial melting. Among them, adhesion wear, high-temperature matrix softening and local melting are the main wear mechanisms.Originality/valueThe influence mechanism of Cu content on the hardness, tensile strength and high temperature resistance of AMCs was explained by microstructure. And the results further help to explore the application of AMCs in high temperature.