Abstract
Carbon-fibre-reinforced cylindrical rods with a biocompatible epoxy matrix subjected to torsion load were investigated. Three kinds of manufacturing processes were used for these rods: hot-pressing as well as winding for unidirectional rods and a combination of winding and braiding. The properties of two kinds of composite rods were determined: one with braided-fabric and another without braided-fabric. Shear fracture tests were conducted with a specially-developed torsion loading facility. The corresponding fractography and deformation behaviour were analysed. The effect of loading rate on shear performance of the rod was also studied. The experimental results led to the conclusion, that owing to the three-dimensional reinforcement effect of braided-fabric, the overall performance of polymer composite rods with braided-fabric is much better than those without braided-fabric.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Composites Part A: Applied Science and Manufacturing
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.