Mechanical Properties and Corrosion Behavior of Dual-Filler-Epoxy-Coated Steel Rebar under a Corrosive Environment

Abstract

The deterioration of steel rebar in reinforced concrete is a major issue that reduces RC structures’ durability and structural integrity. Significant efforts have been devoted to developing high-performance coatings to provide efficient protection of the rebar, and one promising approach is to utilize nanofiller as additives to improve the performance of polymer resins. This study aimed to improve the corrosion resistance of steel rebar by applying an epoxy coating with graphene nanoplatelets (GNPs) and silica nanopowders (NSs) as additives. The corrosion behavior of nanocomposite-coated rebars was characterized via an electrochemical impedance spectroscopy (EIS) test, and salt spray exposure was utilized to evaluate the durability of the coated rebars. Investigation of abrasion resistance and mechanical properties of the coatings was conducted using the falling sand test and tensile coupon test. In addition, the nanocomposites were scanned by micro-CT to explore the effect of binary nanofillers on the intactness of the polymeric matrix. The GNP-NS hybrid filler reduced the void fraction to 0.002%, whereas the void fraction in pure epoxy was 0.07%. Significant reinforcement was found in the mechanical properties; the addition of GNP-NS hybrid filler increased the tensile strength to 37.1 MPa, a 56% increase compared to the pure epoxy. Additionally, the GNP-NS hybrid fillers have led to an improvement of 16% in the Young’s modulus. In terms of corrosion resistance, the Rc value of rebar coated with GNP-NS coating was about three times greater than the ones coated with a single-filler epoxy coating during the initial test, and this value remained undegraded after 200 hr of exposure. In contrast, the group containing hybrid fillers displayed the lowest thickness loss following abrasion testing, with a 74% reduction in thickness loss, showing the coating’s high abrasion resistance. Hence, the results reveal that GNP-NS hybrid fillers have superior wear resistance, mechanical capabilities, anticorrosion properties, and durability. This research provides valuable insights into developing and implementing high-performance polymeric material to protect steel rebars in concrete structures, therefore significantly increasing the sustainability of concrete structures.