Mechanical Characterization of Pultruded GFRP Round Tube under Axial Loading

Abstract

Abstract: Pultruded Fibre‐Reinforced Polymer profiles are widely used as structural elements in many civil infrastructure applications. However, the anisotropic elasticity and the application‐driven slenderness make these profiles prone to local buckling failure, well below their ultimate load capacity. In this paper, an experimental study was undertaken to characterise the tensile and compressive failure of GFRP round tube under axial loading. Based on the research focus of GFRP structures, this work will present a comprehensive study of the mechanical properties of GFRP tubes in terms of both tensile and compressive loads and investigate the mechanical parameters. This paper presents an investigation on the mechanical properties of pultruded Glass fiber reinforced polymer (GFRP) round tubes for structures subjected to tensile and compressive axial loading. The tensile and compressive strength of GFRP round tubes were first tested. For the stability under compression, the slenderness ratio 6 is adopted. The results show that the tensile strength of GFRP tube could reach 580 MPa, while the compressive strength has been around 72% of tensile strength. Also Experimental results showed that specimens exhibited linearly elastic up to failure. Compared with the single tensile failure mode of GFRP tubes, two types of compressive failure modes, including micro-buckling and local buckling were observed. Moreover, a finite element (FE) analysis was carried to simulate the tensile and compressive behaviours of round tube specimen. The comparison between the tensile and compressive peak load values obtained experiment and FE methods revealed that their difference is less than 5%. These indicated that FE analysis predicted reasonably the actual tensile and compressive behaviours of the pultruded GFRP round tube.