Abstract
Fused Deposition Modeling (FDM), a category of Additive Manufacturing (AM) is a versatile form of manufacturing technology that enables the development of the part layer by layer, of any complex geometry. The development and utilization of polymer nanocomposites for has seen a wide range of implementation. The development of polymer nanocomposite by fused deposition technology and evaluation of its mechanical propertieshave been carried out in this study. Polycarbonate (PC) and Acrylonotrile Butadiene Styrene (ABS) are compounded together with carbon nanotubes. Different proportion of Carbon Nano Tubes (CNT) was added as reinforcement at to PC-ABS matrix. Two variations of samples were developed with incremental addition of CNT to PC-ABS. Ultimate tensile strength and impact strength were analyzed for the developed nano composite FDM parts. It was observed that, with the addition of CNT the ultimate tensile strength of the parts increased significantly. Similar trend was seen for impact strength as well.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.