Abstract
The development of polymer nanocomposite blends using multi-walled carbon nanotubes (MWCNTs) and high-density polyethylene (HDPE) is presented in this paper. Fused Filament Fabrication (FFF) based 3D printer is used to realize MWCNT (0.5, 1, 3, and 5 by wt. %)/HDPE nanocomposite (NC) 3D printed samples. The addition of MWCNT increases TCryst, αCryst and TMelt. Thermogravimetric analysis (TGA) of neat HDPE and MWCNT/HDPE NCs is also carried out to check their thermal stability at higher working temperatures. The degradation temperature of MWCNT/HDPE NCs is observed to be higher than neat HDPE and increasing with MWCNT content. The filaments are tested for tensile, while specimens are tested for both tensile and flexural properties. It is observed that tensile and flexural modulus and strength improve with increasing MWCNT. Finally, the results of the tensile tested specimens are compared to those of various HDPE composites found in the literature.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.