Mechanical behaviour of glued-in rods (carbon and glass fibre-reinforced polymers) for timber structures—An analytical and experimental study

Abstract

We address the mechanical response of glued in rods, taking into account parameters such as rod diameter, the material properties of the rods (carbon or glass fibre-reinforced polymer), and the grain orientation of the timber (rods parallel and perpendicular to the timber grain). All the experimental setups employ pull-out tests, where rods are glued in only on one side of the specimen, and these tests are assessed at the premises of the Laboratory for Composite Materials and Composite Structures at the University Claude Bernard Lyon I. In addition, we give an overview and present known design models, technical approvals and regulations, national standards, and guidance papers, comparing the different approaches among them and with the experimental results. Good agreement was shown and further useful results were observed.