Mechanical behavior of glued-in GFRP rod in glubam: Experimental and analytical study

Abstract

Fiber reinforced polymer (FRP) rod is a reasonable alternative to steel rod used in glued-in rod engineered bamboo structures, mainly attributed to its significantly higher strength-weight ratio and excellent corrosion resistance, while this field of study is almost empty. To fill this research gap, a total of 95 glued laminated bamboo (glubam) joints with single glued-in glass FRP (GFRP) rod were tested in a pull-pull tension loading program, aiming to shed light on the influence of anchorage length, rod diameter, bonding length-diameter ratio, glue-line thickness and rod-to-grain angle on the mechanical behavior. Particular emphasis was placed on the initial stiffness analysis and the explanation of the bond-slip mechanism based on the strain distribution of GFRP rod. Approximately 30% and 65% of the glued-in glubam joints can be categorized as the pure bonding failure at the glubam-adhesive interface and the shear failure in the glubam, respectively. It is found that the shear strength and initial stiffness of glubam joint decrease with increasing of the bonding length, the bonding length-diameter ratio, and the glue-line thickness, but the two indexes increase with increasing of GFRP rod diameter. The shear strength and initial stiffness exhibit an initial upward and then downward trend when the rod-to-main fiber direction angle varied from 0° to 90°. The analysis results reveal that the distribution of the local slip stiffness is non-uniform along the bonding length, also meaning that the local bond-slip relationships are varied at different locations. Based on the single-parameter correlation analysis, a strength model and an initial stiffness model are proposed for predicting the mechanical performance of glubam joints with glued-in GFRP rod for a potential application in evaluating actual glubam joints.