Abstract

Abstract Five different WC/C coatings deposited by physical vapour deposition (PVD) on high speed-steel (HSS) have been evaluated with respect to their mechanical and tribological properties. For all coatings a chromium layer was deposited first to enhance coating adhesion. The carbide phase (WC) and the carbon (C) phase were deposited simultaneously by direct-current magnetron sputtering of a WC target and plasma-assisted chemical vapour deposition using hydrocarbon gas, respectively. The influence of the chromium interface layer thickness, the amount of WC phase and the flow of hydrocarbon gas on the mechanical and tribological properties of the coatings have been investigated. The coatings have been characterised with respect to their chemical composition (glow discharge optical emission spectroscopy), hardness (Vickers microhardness), morphology (scanning electron microscopy, SEM), roughness (profilometry), residual stress (beam bending), critical load (scratch testing) and abrasive wear resistance (the “dimple grinder test”). Furthermore, a ball-on-plate test was employed to obtain information about the frictional properties and sliding wear resistance of the coatings. The wear mechanisms and wear debris were analysed by SEM, Auger electron spectroscopy and electron spectroscopy for chemical analysis. All WC/C coatings displayed a thickness between 2 and 4 μm and a surface roughness in the range of 10 to 70 nm. The hardness varied between 1500 and 1800 HV. The coating residual stress was found to range from −2.5 to −0.5 GPa. The scratch test revealed a relatively high critical normal load, i.e., a relatively good adhesion of the WC/C coatings to the HSS. The abrasive wear resistance was found to be very high, in fact equally as high as that of PVD TiN. In the sliding wear test it could be seen that the coating containing the lowest amount of carbide phase (WC), i.e., the highest amount of carbon phase (C), and which had the highest compressive residual stress yielded the lowest friction and wear rate against steel. In addition, this coating was also found to yield the lowest wear rate of the counter material. In summary, a WC/C coating with overall good mechanical and tribological properties was obtained provided a relatively thin chromium layer was deposited first and if a relatively high acetylene gas flow was utilised during deposition of the WC/C layer.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.