Abstract
A facile approach to fabricate graphene oxide (GO) reinforced epoxy resin nanocomposites was developed by transferring GO from water to acetone. Three-point bending test, impact test, dynamic mechanical analysis (DMA) and thermogravimetric analysis (TGA) were used to investigate the mechanical and thermal properties of the nanocomposites. The results showed that significant improvements in flexural strength, flexural modulus, impact strength, and storage modulus were achieved when incorporating ∼1 wt% of graphene oxide. The TGA analysis indicated that the introduction of GO has not demonstrated obvious effect on the thermal stability.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
