Abstract
ABSTRACTThis research evaluates the effects of PLA/PP blend ratio and Lyocell/hemp mixture ratio on the morphology, water absorption, mechanical and thermal properties of PLA‐based composites. The composites were fabricated with 30 mass % hemp using compression moulding. As a reference composites made from PP were also studied. Combining of hemp and Lyocell in PLA composite leads to the reduction of moisture absorption and can improve the impact, tensile, flexural properties when compared with PLA/hemp. Composite based on the PLA/PP blend‐matrix could not improve the tensile and flexural properties compared with PLA/hemp, however; the lighter composite with better impact properties was obtained. The crystallization temperature of the PLA‐PP/hemp increased compared with pure PLA. This result was also confirmed by the SEM micrographs. The moisture absorption of PLA‐PP/hemp was higher than PLA/hemp. Based on theoretical analysis of DMTA data, there was favorable adhesion in all composites. © 2014 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2014, 131, 40534.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.