Abstract
Agricultural plastic films have caused serious plastic pollution. There are many studies that consider mechanical recycling an appropriate system for the recovery of post-consumption agricultural mulch film. The recovery effect of plastic film depends on the mechanical properties, the level of dirtiness of the post-consumption film, and the recycling process itself. In this study, the mechanical properties of four types of polyethylene plastic films with a thickness of 8, 10, 12, and 10μm, weather-resistant, commonly used in Xinjiang cotton fields, were tested. As well as the friction coefficient between the film and soil, the cotton stalk, boll shell, and leaf with different moisture contents were measured. Then, the self-propelled straw chopping and residual film recycling combined machine collected the four types of mulch films. The results showed that the longitudinal mechanical properties of the plastic film were greater than the transversal ones, with the exception of the nominal tensile strain at break, and the tensile characteristics of the mulching film covered with soil were greater than those without soil. The dynamic or static friction coefficient between the film and the contact material had a linear relationship with the moisture content of the material. During the recycling operation, the better the mechanical properties of the plastic film, the higher the pick-up rate of the mulch film. The maximum longitudinal tensile force of 12-μm plastic film was 3.42 N, and the nominal tensile strain at break was 303.09%. The pick-up rate reached more than 93% when the 12-μm plastic film was recovered in autumn, which effectively reduced the residue of plastic film coverage in the current year. Moreover, the more soil that was present on the much film, the greater the soil content of the recycled film roll, and the stalk content also increased, but the change was small. The research provides a reference for the mechanical and the friction features of agricultural plastic film in Xinjiang, and provides a theoretical basis for the formulation of standards for film thickness and mechanical properties, as well as the design and optimization of a residual film collecting machine in the cotton field.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.