Mechanical and flow properties of high‐density polyethylene/low‐density polyethylene blends

Abstract

AbstractThe recycling of plastic waste is of particular interest in large urban areas where municipal waste represents a large ecological problem. To achieve their objective (consumer products from plastic waste), formulators of a recycling program have to understand the implications of working with mixtures of different resins. Furthermore, in a multiphase system, the thermomechanical history experienced by the resins during processing represents an important link between operating conditions, resin properties, and final product performance. High‐density polyethylene/low‐density polyethylene (HDPE/LDPE) blends (10, 20, 35, 50, 65, 80, and 90 percent by weight HDPE) were melt blended in an internal mixer. A complete rheological characterization was performed on each blend. The resulting blends were extruded under different processing conditions. The extruded sheets were further characterized to determine their mechanical properties, The experimental results show important differences in the mechanical properties (transverse and longitudinal) of the sheets obtained from the blends. These differences are explained on the basis of the processing conditions (thermomechanical history) and the rheological properties of the molten blends.