Measuring the saturated hydraulic conductivity of peat substrates in nursery containers

Abstract

Pore size, distribution and continuity are important characteristics for the exchange and storage of air and water in artificial mixes. Saturated hydraulic conductivity (Ks) measurements can be used to obtain such a characterization. However, two difficulties are encountered when using Ks in potting media. First, the validity of Ks may be limited because it may not apply in media composed of coarse material or peat. Second, the structure of peat substrates is very sensitive and in situ measurements of potted peat substrates (i.e. measurements made directly in the pots) should be carried out to avoid any disruptive effect due to handling. Such a measurement, when made in pots, may require the evaluation of the water flux reduction resulting from the container outflow configuration. The objectives of this study were therefore to check the validity of Darcy’s law for peat substrates and to propose an approach for estimating the saturated hydraulic conductivity from flow measurements made in nursery containers. For three different substrates, water flow in artificial mixes followed Darcy’s law for hydraulic gradients ranging from 1.1 to 1.6 cm cm−1. Experimental results showed that the measured fluxes in 5-L nursery container filled at five different substrate heights (9, 11.5, 14, 16.5 and 19 cm) with laterally located drainage holes were significantly different from those measured in pots with the bottom removed (therefore equivalent to measurement currently made in cylinders) at P = 0.0022. Fluxes in containers with bottoms removed were 7–31% higher than in intact pots. Water flux measurements may therefore need to be corrected for this flux reduction in order to accurately estimate hydraulic conductivity from flow experiments run in pots. A correction factor based on the results obtained from a finite difference model was derived and calibrated. Then, this correction factor was used to convert flux measurements made in pots with lateral holes into equivalent flux that would have been obtained had the pot had an open bottom. After correction, no significant flux reductions were found between pots with open bottoms and pots with lateral holes (P = 0.55). A correction factor estimated from Laplace’s equation, once calibrated, can therefore be applied to flux measurements obtained from pots to obtain estimates of Ks of undisturbed potted media. Key words: Hydraulic conductivity, peat substrates, container