Abstract
The paper reports new measurements of the thermal conductivity of molten lead at temperatures from 600 to 750 K. The measurements have been carried out with an updated version of a modified transient hot-wire (THW) method, where the hot-wire sensor is embedded within an insulating substrate with a planar geometry. However, unlike previous sensors of the same type, the updated sensor works with the hot-wire divided into three thermally isolated parts. The operation of this sensor has been modeled theoretically using a finite-element (FE) analysis and has subsequently been confirmed by direct observation. The new sensor is demonstrated to have a higher sensitivity and a better signal-to-noise ratio than earlier sensors. Molten lead is used as the test fluid. It has the lowest thermal conductivity of any material we have yet studied. This allows us to probe the limits of our sensor system for the thermal conductivity of high-temperature melts. It is estimated that the uncertainty of the measurements is 3% over the temperature range studied. The results are used to examine the application of the Wiedemann–Franz (W-F) relationship.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
