Abstract
Measurements of the Segmentation Frequency in the Chip Formation Process This investigation has showed that the relationship between the chip formation process and the dynamic cutting forces in the shear zone is probably one of the most essential features of the cutting process. In the cutting tests conventional accelerometers and a special new cutting force sensor have been used. Also metalographic samples from the chips have been studied. By comparing the information from the transducers and the metalographic samples, extended experiments and tests have showed that this method can be very useful for the basic understanding of the mechanisms of the cutting process. Also flank wear and tool damage propagation can be measured by this method. The results in this work are discussed and described in the paper. Also the possibilities of in-process measurements for adaptive control are discussed.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
