Abstract
The objective of this paper is to propose a measuring method based on the spray momentum flux measurement of each nozzle hole that could be used to determine the transient discharge coefficient of each nozzle hole of a multi-hole diesel injector. For this purpose, a measurement system for the transient discharge coefficient of each nozzle hole was established utilizing a conventional injection system of pump-line-nozzle and a dedicated constructed experimental rig. By measuring the spray momentum flux of each nozzle hole of the multi-hole fuel injector and injection pressure of the pump-pipe-injector fuel delivery system, the discharge coefficient of each nozzle hole was obtained, and analyzed throughout the injection duration and with different injection pump speeds and cycle fuel injection quantities. The results show that the transient discharge coefficient of each nozzle hole changes constantly, meanwhile, the variations of the transient discharge coefficient of the nozzle holes were similar. However, the discharge coefficient of the nozzle holes were not uniform at the same operating condition and that of the No.5 was apparently lower than that of the others. With increasing cam speed, the fluctuations of the discharge coefficients were variably stable at the maximum needle position.The fluctuations of the discharge coefficients of the nozzle holes were higher for the smaller cycle fuel injection quantity, but as the fluctuation gradually became smaller, the mean discharge coefficient of each nozzle hole increased slightly with increasing cycle fuel injection quantity.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
