Measurement of unstable burning velocities of iso-octane–air mixtures at high pressure and the derivation of laminar burning velocities

Abstract

A new technique is reported for measuring burning velocities at high pressures in the final stages of two inwardly propagating flame kernels in an explosion bomb. The flames were initiated at diametrically opposite spark electrodes, close to the wall, in quiescent mixtures. Measurements of pressure and flame kernel propagation speeds by high-speed photography showed the burning velocities to be elevated above the corresponding laminar burning velocities as a result of the developing flame instabilities. The enhancement increased with increase in pressure and decreased with increase in Markstein number. When the Markstein number was negative, instabilities could be appreciable, as could the enhancement. For the iso-octane–air mixtures investigated, where the mixtures had well-characterised Markstein numbers or critical Peclet numbers at the relevant pressures and temperatures, it was possible to explain the enhancement quantitatively by the spherical explosion flame instability theory of Bechtold and Matalon, provided the critical Peclet number was that observed experimentally, and allowance was made for the changing pressure. With this theoretical procedure, it was possible to derive values of laminar burning velocity from the measured values of burning velocity over a wide range of equivalence ratios, pressures, and temperatures. The values became less reliable at the higher temperatures and pressures as the data on Markstein and critical Peclet numbers became less certain. It was found that with iso-octane as the fuel the laminar burning velocity decreased during isentropic compression.