Measurement of the energy penetration depth into solid targets irradiated by ultrashort laser pulses

Abstract

The energy penetration depth of a short (100 fs) Ti-sapphire laser pulse (0.8 &mgr;m) of intensity 3x10(16) W/cm(2), in solid density materials has been measured. High-Z (BaF2) and low-Z (MgF2) solid layers targets were used. The penetration depth was determined from the measurement of the x-ray emission spectra, as a function of the target thickness. The investigation of these spectra showed that in the low-Z case, solid density material to a depth of 50 nm was heated to a peak electron temperature of approximately 150 eV. For the high-Z material, the penetration depth corresponding to this temperature exceeded 100 nm. This is evidence of a larger heat penetration depth in a high-Z material in comparison to a low-Z material. A model based on electron heat conduction is used to estimate the energy penetration depth. It is suggested that the larger heat penetration in high-Z material is due to heating of the material, caused by the radiation flux, generated by the electron heat conduction.