Abstract
The reflection off an open ended coaxial probe pressed against a material under test is used to determine the complex microwave (1 MHz–20 GHz) dielectric response of the material. A full-wave analysis of the aperture admittance of the probe, in terms of the dielectric properties of the backing material and the dimensions of the experimental geometry, is given. We discuss the calibration procedure of the setup and present the complex dielectric response of several materials determined from the measured reflection coefficient. The results obtained with the open ended coax interpolate well between data taken at lower and higher frequency bands using different experimental methods. We demonstrate that this method can be applied to perform dielectric measurements at cryogenic temperatures.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.