Abstract

Abstract: This study presents the experimental setup and results of measurement of forces and moments in a manually operated ram press machine. Tests were conducted on a BP30 ram press using electrical resistance strain gauges to measure forces present in the machine under operating conditions. The forces were obtained by capturing data for the strains in six channels, using a digital instrument system, and later calculated by using the sensitivity factors. A method was proposed to estimate the tension force and bending moment in the connecting rods based on the sums and differences of measured strains. Results obtained were converted into spreadsheet data and presented in graphs versus the position angle of the operating lever.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.