Measurement of Local Electrode Potentials in an Operating PEMFC Exposed to Contaminants

Abstract

The use of a three-electrode cell, in which the potential of a working electrode can be accurately measured vs. a reference electrode (RE), is a standard practice in liquid-phase electrochemical experiments. However, the geometric constraints of a working PEMFC make use of a RE challenging. Incorporation of a RE into an operating PEMFC typically requires experimental compromises that prevent precise and accurate measurements from being obtained, and do not allow accurate spatial resolution of potential variation along the electrodes. As a result, PEMFC experiments are often performed using the PEMFC anode, which remains within a few mV of 0 V vs RHE during typical operation, as a pseudo RE. Recently, the National Physical Laboratory (NPL) developed an effective technique for accurate in situ monitoring of local electrode potentials in a PEMFC. By inserting REs from the back side of the MEA, the NPL configuration eliminates the edge effects, lack of anode vs. cathode specificity, Ohmic losses, and current density distribution disruptions that have compromised previous fuel cell RE experiments. We report here on the use of this RE technique to monitor local electrode potentials in an operating PEMFC during exposure to CO gas (Figure 1). CO is a common impurity in H2 gas and is known to poison Pt-based anodes. Levels of CO present in H2 fuel are expected to be in the ppb range for cells operating on pure H2 and the ppm range or higher for cells operating on reformate. Use of an RE can reveal the distribution of CO losses, and can also enable losses on the anode to be distinguished from those on the cathode. The results of this work demonstrate a new diagnostic capability that enables improved understanding of local conditions during PEMFC operation during transient or steady state operation. Figure 1. Cell voltage (orange) and anode potential (blue) of a MEA operating at 1 A/cm2 with anode exposed to 20 ppm CO. CO was removed from the anode feed at t = 47 min. Gore MEA, with anode/cathode loading of 0.4/0.1 mg/cm2, 80°C, 100% RH, 100 kPaabs. Figure 1