Abstract

In an effort to find a means of recording absolute systemic arterial pressure from the skin surface, steady pressures in rubber-walled models were recorded with external pressure-sensing devices. The recorded pressure at which a plateau appeared was dependent on the degree of stretch in the wall of the pressure source. Distortion of the wall of the source by the pressure sensor resulted in a recorded curve with no plateau. The area of the sensor was critical; those with diameters greater than that of the source recorded only part of the internal pressure. When the diameter of the sensor was less than that of the source, a fairly linear relationship between recorded and source pressure could be obtained, but interposition of sponge rubber to simulate tissues lying between the artery and the body surface produced nonlinear responses. It was concluded that external sensors are adequate to record the waveforms of arterial pressure but cannot be reliably calibrated to provide accurate measurement of its level. sensing device, arterial pressure; systemic pressure; measurement, external; internal pressures, measurement of; transcutaneous arterial pressures; arterial pressure sensing; external measurement of systemic pressures Submitted on July 8, 1963

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.