Abstract
This study introduced the SiC micro-heater chip as a novel thermal evaluation device for next-generation power modules and to evaluate the heat resistant performance of direct bonded copper (DBC) substrate with aluminum nitride (AlN-DBC), aluminum oxide (DBC-Al2O3) and silicon nitride (Si3N4-DBC) ceramics middle layer. The SiC micro-heater chips were structurally sound bonded on the two types of DBC substrates by Ag sinter paste and Au wire was used to interconnect the SiC and DBC substrate. The SiC micro-heater chip power modules were fixed on a water-cooling plate by a thermal interface material (TIM), a steady-state thermal resistance measurement and a power cycling test were successfully conducted. As a result, the thermal resistance of the SiC micro-heater chip power modules on the DBC-Al2O3 substrate at power over 200 W was about twice higher than DBC-Si3N4 and also higher than DBC-AlN. In addition, during the power cycle test, DBC-Al2O3 was stopped after 1000 cycles due to Pt heater pattern line was partially broken induced by the excessive rise in thermal resistance, but DBC-Si3N4 and DBC-AlN specimens were subjected to more than 20,000 cycles and not noticeable physical failure was found in both of the SiC chip and DBC substrates by a x-ray observation. The results indicated that AlN-DBC can be as an optimization substrate for the best heat dissipation/durability in wide band-gap (WBG) power devices. Our results provide an important index for industries demanding higher power and temperature power electronics.
Highlights
Silicon carbide (SiC) and gallium nitride (GaN), are wide band-gap (WBG) semiconductors, are strongly recognized as the best materials for the power electronics applications demanding higher power and higher temperature [1,2]
The results indicated that the failures may impress that the aluminum nitride (AlN) and Al2O3 have critical disadvantage of higher coefficient of thermal expansion (CTE) value and lower toughness than Si3N4
No delamination of the ceramic or degradation of the Ag sinter joint occurred during power cycling tests, and it was clearly found that the temperature rise did not cause physical failure
Summary
Silicon carbide (SiC) and gallium nitride (GaN), are wide band-gap (WBG) semiconductors, are strongly recognized as the best materials for the power electronics applications demanding higher power and higher temperature [1,2]. Since these WBG semiconductors have superior properties, kind of a wide band gap (>3 eV), a high critical electric field (>3 MV/cm) and a high saturation velocity (>2 × 107 cm/s), SiC and GaN can enable to overcome the ultimate performances reached by silicon (Si) based devices, in terms of power conversion efficiency [3]. All the layers have different material properties like a coefficient of thermal expansion (CTE), which causes thermos-mechanical stress during repetitive operating [10,11]
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
