Abstract
The crack compliance, or slitting, method was used to measure a localized depth profile of residual stresses in a metal-matrix composite. The composite consisted of a matrix of Kanthal, a Fe–Cr–Al refractory alloy, reinforced with continuous uniaxial tungsten fibers. The stress measurements involved successively deepening a narrow slit between the fibers in the matrix, and measuring the resulting deformations with a surface strain gage. The depth profile of the in-plane residual stress components was determined from the measured strains using an eigenstrain-based extension of the residual stress calculation scheme normally used for slitting measurements. To validate some of the eigenstrain assumptions, the measured residual stresses were compared with the predictions from a thermomechanical finite element model. The model used a mesh of the actual fiber arrangement in the composite specimen rather than the commonly used unit-cell model. Compared to other techniques for measuring residual stresses in composites, the slitting measurements provided spatial resolution to a small fraction of the fiber diameter, which is useful when validating a thermomechanical model. Coincidentally, this is the first reported slitting method measurements of shear residual stresses.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.