Measurement and Analysis of the Vibration Responses of Piano Soundboards with Different Structures.

Abstract

The effect of structure on the vibration response was explored for four piano soundboards with different but commonly adopted structures. The vibration response was obtained using the free-vibration method, and the values of the dynamic modulus of elasticity and dynamic shear modulus obtained using the free-vibration frequency method (EF and GF) were compared with the dynamic modulus of elasticity obtained using the Euler beam method (EE) and dynamic shear modulus obtained using the free-plate torsional vibration method (GT), respectively. It was found that the soundboards with different structures had different vibration modes and that excitation at different locations highlighted different vibration modes. For all the soundboards analyzed, the EE and GT were higher than EF and GF by 2.2% and 24.3%, respectively. However, the trends of the results of these methods were the same. The four piano soundboards with different structures possessed varying dynamic moduli of elasticity and dynamic shear moduli. These rules are consistent with the grain directions of the soundboards and the anisotropy of the wood (the direction of the units of the soundboards). The results show that the vibration mode of the piano soundboard is complex. The dynamic elastic modulus of the soundboard can be calculated using the Euler beam method. The results provide a reference for studies on the vibration response, material selection, production technology, and testing of piano soundboards.