Measurement and analysis of the crown conical degree of maxillary incisors in patients with congenital tooth agenesis caused by different gene mutations

Abstract

Objective: To measure the crown conical degree of the remaining maxillary incisors in patients with congenital tooth agenesis, and to analyze the influence of different gene mutations on the crown conical degree of patients. Methods: Whole exome sequencing was performed on 85 patients with congenital tooth agenesis (50 males, 35 females, median age 19 years old) who visited the Department of Prosthodontics, Peking University School and Hospital of Stomatology from January 2019 to January 2023. The pathogenic gene was identified. The width of the crowns of the maxillary central and lateral incisors at the incisal 1/3 and gingival 1/3 were measured on the panoramic radiograph, and the ratio was defined as the crown conical degree. The smaller the ratio is, the more likely is the crown to be peg shaped teeth. The control group was matched by age and gender with 85 other patients with intact maxillary permanent incisors who were treated in the Department of Prosthodontics, Peking University School and Hospital of Stomatology from January 2019 to January 2023. The conical degree of the tooth agenesis group was compared with the control group by t-test, and the differences in the crown conical degree in different gene mutation groups were compared using one-way analysis of variance, and the multiple comparisons among gene groups were carried out using the LSD method. Results: Among the 85 tooth agenesis patients, the numbers of patients in each gene mutation group were 20 in ectodysplasin A (EDA) group, 8 in ectodysplasin A receptor (EDAR) group, 15 in wingless-type MMTV integration site family, member 10A (WNT10A) group, 16 in paired box 9 (PAX9) group, 10 in Msh homeobox 1 (MSX1) group, 10 in low-density Lipoprotein receptor related protein 6 (LRP6) group, and 6 in bone morphogenetic protein4 (BMP4) group. The number of missing teeth were 1-27, median number 15 among the tooth agenesis patients. There was no significant difference in the conical degree between the left and right homonymous teeth in the congenital tooth agenesis group and the control group (P>0.05). The crown conical degree of maxillary central incisor and lateral incisor in the congenital missing teeth group (0.95±0.24, 0.90±0.22) was significantly smaller than that in the control group (1.12±0.09, 1.13±0.09) (t=-8.50, P<0.001; t=-11.47, P<0.001). In WNT10A mutants, the conical degree of lateral incisors (0.89±0.18) was less than that of central incisors (1.07±0.15)(t=3.68, P<0.001). The conical degree of central incisors and lateral incisors (0.70±0.23, 0.57±0.15) of EDA mutants was significantly lower than that in patients with other gene mutations (P>0.05). Conclusions: Compared with the normal control group, the remaining maxillary central and lateral incisors of the seven gene mutation groups of patients with congenital tooth agenesis all had different degrees of conical crown. Among them, the crown conical degree of maxillary central and lateral incisors of the EDA mutation was the most severe, and the WNT10A mutation affected the maxillary lateral incisors more specifically.