MCSCF study of singlet oxygen addition to ethenol?a model of photooxidation reactions of unsaturated and aromatic compounds bearing hydroxy groups

Abstract

The reaction path of singlet (1Δg) oxygen addition to ethenol (vinyl alcohol)—a model of the reactions of singlet oxygen with aromatic and unsaturated compounds bearing the hydroxy groups—has been studied by means of MCSCF calculations, using various active spaces and basis sets. The effects of dynamic correlation (at the PT2 level) and basis set superposition error (BSSE) on relative energies were also investigated. It was found that including polarization functions is necessary to obtain geometries of the oxygen moiety consistent with the available experimental data. Two possible reaction products were considered: 1-hydroxy-1,2-dioxethane (peroxide) and 2-hydroperoxyethanal-1 (hydroperoxide); their energies are 24.1 and 36.6 kcal/mol (44.1 and 78.2 kcal/mol with the PT2 contribution and BSSE correction) below the dissociation limit, respectively (all energies reported here refer to the 6-31G** basis set and an active space composed of eight orbitals and ten electrons). A common stage of both reactions is the formation of a peralcoxyl intermediate with one of the oxygen atoms attached to the unsubstituted carbon atom; the energies of the respective transition state and that of the intermediate are 30.2 and 18.7 kcal/mol (15.9 and 10.3 kcal/mol with the PT2 contribution and BSSE correction) above the dissociation limit, respectively. The energy of this transition state is the dominant energy barrier to the reaction. The intermediate can then undergo conversion to the dioxethane product, to the perepoxide intermediate, or via a proton transfer, directly to the hydroperoxide, the last route being the most probable one. The perepoxide intermediate, after a proton transfer, also readily gives the hydroperoxide. It was also found that the unimolecular conversion from dioxethane to hydroperoxide via a proton transfer from the hydroxy group accompanied with ring cleavage requires an activation energy of at least 56 kcal/mol, making this reaction path highly improbable. © 1997 John Wiley & Sons, Inc. J Comput Chem18: 1668–1681, 1997