Maximum dorsiflexion increases Achilles tendon force during exercise for midportion Achilles tendinopathy.

Abstract

Rehabilitation is an important treatment for non-insertional Achilles tendinopathy. To date, eccentric loading exercises (ECC) have been the predominant choice; however, mechanical evidence underlying their use remains unclear. Other protocols, such as heavy slow resistance loading (HSR), have shown comparable outcomes, but with less training time. This study aims to identify the effect of external loading and other variables that influence Achilles tendon (AT) force in ECC and HSR. Ground reaction force and kinematic data during ECC and HSR were collected from 18 healthy participants for four loading conditions. The moment arms of the AT were estimated from MRIs of each participant. AT force then was calculated using the ankle torque obtained from inverse dynamics. In the eccentric phase, the AT force was not larger than in the concentric phase in both ECC and HSR. Under the same external load, the force through the AT was larger in ECC with the knee bent than in HSR with the knee straight due to increased dorsiflexion angle of the ankle. Multivariate regression analysis showed that external load and maximum dorsiflexion angle were significant predictors of peak AT force in both standing and seated positions. Therefore, to increase the effectiveness of loading the AT, exercises should apply adequate external load and reach maximum dorsiflexion during the movement. Peak dorsiflexion angle affected the AT force in a standing position at twice the rate of a seated position, suggesting standing could prove more effective for the same external loading and peak dorsiflexion angle.