Maximum Copper and Tin Contents in LC‐steel Thin Strip ‐ Hot Shortness Model Calculations

Abstract

For conventional casting processes low copper and tin contents have to be ensured in LC‐steel to avoid hot shortness. It is expected that higher cooling rates, e.g. in thin strip casting, permit higher copper and tin limits. Hot shortness occurs because of selective oxidation of the iron whereby the more noble copper is enriched at the steel‐oxide interface. A liquid metallic copper phase which wets the grain boundaries supports cracking during hot deformation. The enrichment of the liquid copper phase depends on the oxidation temperature: At low temperatures copper is solid, cannot wet the steel surface and is incorporated into the growing oxide layer. At mid temperatures (1083‐1177 °C) the copper phase is liquid, wets the grain boundaries of the steel surface and causes hot shortness. At high temperatures a liquid fayalitic slag is formed in the oxide layer if the steel contains silicon. The fayalitic phase occludes parts of the steel surface and removes copper from the steel surface; then hot shortness is reduced or even avoided. Other mechanisms to remove copper from the steel surface need the presence of Fe3O4 and Fe2O3 in the oxide layer. These iron oxides are not formed for short oxidation times where linear oxidation takes place. Diffusion of copper into the steel is too slow to reduce hot shortness if copper has an elevated concentration in the steel, e.g. 0.5 wt.‐%. Therefore, only the occlusion mechanism is of importance during linear oxidation. A model is established on the basis of these observations in order to predict an upper copper limit in dependence of the steel strip thickness (cooling behaviour) and the oxygen content in the cooling atmosphere (nitrogen‐oxygen mixture). The model is compared to experimental results from KIMAB which are presented in this issue. It is demonstrated that a copper layer thickness of 0.098 μm at the steel‐oxide interface is sufficient to cause cracks of a depth of more than 0.2 mm. For strip thicknesses below 5 mm a simple approximation can be used to predict the maximum copper content in LC‐steel to avoid hot shortness. For example, thin strip of a thickness of 2 mm will have no cracks (above 0.2 mm) even if 0.7 wt.‐% of copper is contained in the LC‐steel. For atmospheres with a reduced oxygen partial pressure even higher copper contents are possible.Tin is with short oxidation times not a problem concerning hot shortness, as shown by the KIMAB results. This may be explained by the much higher diffusivity of tin in iron compared to copper.